ISO INTERNATIONAL STANDARD 17357-2 First edition 2014-01-15 Ships and marine technology Floating pneumatic rubber fenders - Part 2: Low pressure Navires et technologie maritime - Eperons pneumatiques flottants- Partie 2: Basse pression Reference number ISO 17357-2:2014(E) ISO @IS02014 No reproo Not for Resale IS0 17357-2:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproduction or networking permited without license from IHS Not for Resale IS0 17357-2:2014(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references 3 Terms and definitions ..1 4 Classification .3 4.1 Low-pressure fender types .3 4.2 Initial internal pressure .3 5 Ordering information .3 5.1 Information to the manufacturer .3 5.2 Information from the manufacturer .3 6 Low-pressure fender requirements .3 6.1 Clamped end fender requirements .3 6.2 Moulded end fender requirements ..4 6.3 Size requirements. .5 7 Performance. .5 7.1 Specification of performance. .5 7.2 Performance curves. 5 7.3 Fender performance. 5 8 Performance confirmation of prototype fender test .5 8.1 General .5 8.2 Performance test, parallel compression test .6 8.3 Angular compression test .6 8.4 Durability test. .6 8.5 Compression recovery test .7 8.6 Puncture resistance test. .7 8.7 Recording condition. 7 9 Test and inspection for commercial fenders. .7 9.1 General .7 9.2 Test of the fender body material 9.3 Dimensional inspection. .8 9.4 Air leakage test. ..8: 9.5 Hydrostatic pressure test ..8 10 Marking ..9 11 Documentation. .9 12 Inspection and evaluation by a qualified independent inspection service ..10 Bibliography ..14 iii ded by IHS under lic se with ISt ed without license from IHS Not for Resale