ISO INTERNATIONAL STANDARD 16463 Second edition 2014-05-01 Polycristalline diamond inserts, tipped Dimensions, types Plaquettes brasees en diamant polycristallin - Dimensions, types Reference number IS0 16463:2014(E) LSO IS02014 HS under ted without license from IHS Not for Resale IS0 16463:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved Not for Resale IS0 16463:2014(E) Contents Page Foreword ..iv 1 Scope 1 2 Normative references .1 3 Insert shapes and design 3.1 Insert shapes 1 3.2 Normal clearance, an 1 3.3 Cutting edge corner. 1 3.4 Tolerance class 3.5 Design of cutting edges 1 3.6 Insert type. .2 4 Designation .2 4.1 General .2 4.2 Designation of a tipped insert for turning .2 4.3 Designation of a tipped insert for milling .2 5 Dimensions. .2 5.1 Insert shape T with fixing hole (inserts for turning) .2 5.2 Insert shape T without fixing hole (inserts for turning) .4 5.3 Insert shape S with fixing hole (inserts for turning) .5 5.4 Insert shape S without fixing hole (inserts for turning) 5.5 Insert shape C with fixing hole (inserts for turning) 6 5.6 Insert shape D with fixing hole (inserts for turning) ..8 5.7 Insert shape V with fixing hole (inserts for turning) .8 5.8 Insert shape S with fixing hole (inserts for milling) .9 5.9 Insert shape C with fixing hole (inserts for milling) .10 5.10 Insert shape W with fixing hole (inserts for turning) .10 6 Cutting edge length, l1, of tipped inserts .11 6.1 General ..11 6.2 Inserts with radius. .11 6.3 Inserts with wiper edge .12 7 Base material, cutting material ..12 8 Measurements ..13 9 Marking .13 Annex A (informative) Relationship between designations in IS0 16463 and IS0/TS 13399-2.. ...14. iii Stal ded by IHS under: se with ISt ed without license from IHS Not for Resale