ISO INTERNATIONAL STANDARD 16380 Firstedition 2014-06-01 Road vehicles Blended fuels refuelling connector Vehicules routiers - Pistolet de remplissage pour les melanges de carburants gazeux Reference number ISO 16380:2014(E) ISO International Organization for Standardization Zhejiang Institute of Standardization 5956617 IS02014 No reproduction or networking permitted without license from IHS IS0 16380:2014(E) COPYRIGHTPROTECTEDDOCUMENT ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland Prganizationfor Standardization Not for Resale, 2015/3/11 02:26:23 etworking permitted without license from IHS IS0 16380:2014(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope 2 Normative references 3 Terms and definitions 4 General construction requirements 5 Nozzles ..5 6 Standard receptacle dimensions. ..6 6.1 Standard receptacle dimensions Size 1 (M200, M250, M350) .6 6.2 Standard receptacle dimensions size 2 (N200, N250) ..10 7 Receptacles ..12 8 Instructions .12 9 Marking ..13 10 Tests. .14 10.1 General requirements .14 10.2 User interface. .14 10.3 Impact resistance .15 10.4 Receptacle protective caps. .15 10.5 Leakage at room temperature .15 10.6 Valve operating handle 16 10.7 Abnormal loads .16 10.8 Rocking/twisting. 17 10.9 Mounting hardware torque .18 10.10 Leakage test at low and high temperatures 18 10.11 Durability 19 10.12 Hydrostatic strength 22 10.13 Corrosionresistance 22 10.14 Deformation 23 10.15 Non-igniting evaluation 23 10.16 Vibration resistance.. .23 10.17 Hydrogen embrittlement 23 10.18 Pressure tight protective cap (PTPC) 24 Annex A (informative) Table of nozzle characteristics .32 Annex B (informative) Manufacturing and production test plan .33 Annex C (informative) Receptacle test fixture .34 Annex D (informative) Nozzle clearance dimensions ..44 Bibliography .45 iii vided by IHS under lic ed without license from IHS