ISO INTERNATIONAL STANDARD 16365-1 First edition 2014-05-01 Plastics Thermoplastic polyurethanes for moulding and extrusion - Part 1: Designation system and basis for specifications Plastiques Polyuréthannes thermoplastiques pour moulage et extrusion Partie 1: Systeme de désignation et base de speécification Reference number IS0 16365-1:2014(E) ISO International Organization for Standardization @ IS0 2014 =Zhejiang Institute of Standardization 5956617 ted without license from IHS IS0 16365-1:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +4122 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland Internationai br DrganizationforStandardization Not for Resale, 2015/3/11 02:25:56 No reproduction or networking permited without license from IHS IS0 16365-1:2014(E) Contents Page Foreword ..iv 1 Scope ..1 2 Normative references 3 Designation system 3.1 General ..2 3.2 Data block 1 3.3 Data block 2 .3 3.4 Data block 3 3.5 DataBlock4 .5 3.6 Data block 5 .7 4 Examples of designations 7 Bibliography 9 ntemaional oganzation@sS204 -All rights reserved ii icenseeZhejiang Institute of Standardization 5956617 vided by IHS under I se with ISt ed without license from IHS