ISO INTERNATIONAL STANDARD 16063-16 First edition 2014-06-01 Methods for the calibration of vibration and shock transducers - Part 16: Calibration by Earth's gravitation Méthodes pour I'étalonnage des transducteurs de vibrations et de chocs Partie 16: Etalonnage par gravitation tellurique Reference number IS0 16063-16:2014(E) LSO @ IS0 2014 I without license from IHS Not for Resale IS0 16063-16:2014(E) COPYRIGHTPROTECTEDDOCUMENT ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 16063-16:2014(E) Contents Page Foreword ..iv 1 Scope 1 2 Normative references ..1 3 Uncertainty of measurement 4 Requirements for apparatus and other conditions .2 4.1 General 2 4.2 Environmental conditions .2 4.3 Mounting platform. 2 4.4 Accelerometeroutputmeasuringinstrumentation .3 4.5 Earth's gravitation. 3 5 Method .3 5.1 General .3 5.2 Test procedure for 0° and 180° 4 5.3 Test procedure for fractions of gravitation .4 5.4 DC offset consideration. .5 5.5 Calibration setup .6 6 Report of calibration results ..8 Annex A (normative) Uncertainty components in the calibration by gravitation .9 Bibliography .11 iii ense with ISt thout license from IHS Not for Resale