ISO INTERNATIONAL STANDARD 14856 First edition 2001-02-01 Timekeeping instruments Wristwatch- cases Fixing dimensions of non-spring- bar types Instruments horaires - Boites de montres-bracelets - Dimensions de fixation des types sans barrette Reference number ISO 14856:2001(E) ISO @ ISO 2001 ISO 14856:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2001 ber body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland ii @ ISO 2001 - All rights reserved ISO 14856:2001(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical com- mittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeenestablishedhasthe righttoberepresentedonthatcommittee.Internationalorganizations,governmentalandnon-governmental,inlial son with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. patent rights. IsO shall not be held responsible for identifying any or all such patent rights. SC 7, Overall dimensions. @ ISO 2001 - All rights reserved ii