ISO INTERNATIONAL STANDARD 24035 First edition 2014-05-01 Belt drives V-belts and the corresponding pulleys for agricultural machineries Dimensions Transmissions par courroies Courroies trapézoidales et poulies correspondantes pour les machines agricoles - Dimensions Reference number IS0 24035:2014(E) ISO @IS02014 HS under I Not for Resale IS0 24035:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved or networking permited without license from IHS Not for Resale IS0 24035:2014(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references 3 Terms and definitions 4 Symbols. 5 Belt cross-sections and nominal dimensions 6 Beltlengths ..3 7 Belt length measurement method - Manufactured belt dimensions. 8 Specifications for pulleys used with V-belts and V-ribbed belts ..9 Bibliography .10 Copyritnteatinal rganiason t? Sanaizal rights reserved ii d by IHS under I ed without license from IHS Not for Resale