ISO INTERNATIONAL STANDARD 23013 First edition 2016-01-15 Road vehicles Determination of resistance to forced entry of security glass constructions used in vehicle glazing Test of glazing systems Vehicules routiers - Détermination de la résistance a la force d'intrusion des constructions de vitres de sécurite utilisées dans les vitrages de vehicules Essai des systemes de vitrages Reference number IS0 23013:2016(E) ISO International Organization for Standardization @IS02016 HS unde ted without license from IHS IS0 23013:2016(E) COPYRIGHT PROTECTEDDOCUMENT Is02016,PublishedinSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Licensee-ZHEJIANG INST OF STANDARDIzRoISQ 6 - All rights reserved ded by IHS unde Not for Resale, 2016/3/29 02:56:20 networking permited without license from IHS IS0 23013:2016(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ...1 2 Normative references 3 Terms and definitions 4 Principle 5 Apparatus ..4 5.1 Description of the apparatus .4 5.1.1 General. 5.1.2 Tool for pointed attack. .6 5.1.3 Tool for blunt attack. .7 5.1.4 Tool for cutting attack .7 5.1.5 Tool for displacement test ..8 5.2 Checking the equipment 10 5.2.1 Determining the effective mass and checking the speed measuring apparatus... 10 5.2.2 Pointed attack .11 5.2.3 Blunt attack .11 5.2.4 Cutting attack ..11 5.2.5 Displacement test. .11 6 Test pieces ..12 6.1 Support frame for the system part. .12 6.2 Associated sections of the car body .12 6.3 Security glazing . ..12 6.4 Number of panes of glazing. ..13 7 Test conditions ..13 8 Test procedures .13 8.1 General. .13 8.2 Attack test sequence with blunt tool. .14 8.2.1 General. ..14 8.2.2 Test element pointed attack .14 8.2.3 Test element blunt attack. ..14 8.2.4 Test element displacement ..14 8.2.5 Test position and requirements for different levels of attack resistance ..14 8.3 Attack test sequence with cutting tool. ..15 8.3.1 General. .15 8.3.2 Test element pointed attack ..16 8.3.3 Test element cutting attack .16 8.3.4 Test element displacement ..16 8.3.5 Test position and requirements for different levels of attack resistance ..16 9 Classification ..18 10 Test report ..18 11 Test certificate. ..19 Annex A (informative) Comments ..20 Annex B (informative) Source of steel pin for the pointed attack tool. ..21 Bibliography .22 jii Licensee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 ed without license from IHS Not for Resale, 2016/3/29 02:56:20