ISO INTERNATIONAL STANDARD 22915-1 Secondedition 2016-01-15 Industrial trucks Verification of stability - Part 1: General Chariotsdemanutention-Verificationdela stabilité- Partie1:Generalités Reference number IS0 22915-1:2016(E) LSO Intermational Organization for Standardization =ZHEJIANG INST OF STANDARDIZATION C1 5956617 @IS02016 No reproduction or networking permitted without license from IHS IS022915-1:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS02016,Published inSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8. CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +4122 749 09 47 [email protected] www.iso.org Intemationaibr PrganizationforStandardization Uicensee-ZHEJIANG INSTOF STANDARDIZoISQ,6-All rights reserved etworking permitted without license from IHS NotforResale, 2016/3/29 02:56:12 IS022915-1:2016(E) Contents Page Foreword ..iv Introduction.. 1 Scope.. 2 Normative references 3 Terms and definitions ..2 4 Stabilitytestsfortrucks. 4.1 Test procedure .4 4.2 Verification procedure ..4 4.2.1 Operation ofthetilttable and test criteria .4 4.2.2 Calculation. 4.2.3 Othermethods 4 4.3 Testconditions .4 4.3.1 Condition of the truck 4 4.3.2 Positionofthetruckonthetilttable .5 4.3.3 Test load, lift height, and standard load centre distance .5 4.4 Safety precautions for testing. .6 4.5 Stability verificationfor trucks with attachments .7 Bibliography .8 Intematinal oganzation @stS.20.1.6 - All rights'reserved iii See=ZHEJIANG INSTOFSTANDARDIZATION C15956617 thout license from IHS