ISO INTERNATIONAL STANDARD 16143-2 Secondedition 2014-05-15 Stainless steels for general purposes- Part 2: Corrosion-resistant semi-finished products, bars, rods and sections Aciers inoxydables pour usage general Partie 2: Demi-produits, barres, fils machine et profils en acier résistant a la corrosion Reference number IS0 16143-2:2014(E) LSO @ IS0 2014 Not for Resale IS0 16143-2:2014(E) COPYRIGHTPROTECTEDDOCUMENT ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 16143-2:2014(E) Contents Page Foreword ..iv 1 Scope 2 Normative references .1 3 Terms and definitions 4 Designation .2 5 Information to be supplied by the purchaser ..2 6 Classification of grades .3 7 Requirements .3 7.1 Manufacturing process .3 7.2 Delivery condition .3 7.3 Chemical composition .3 7.4 Susceptibility to intergranular corrosion .4 7.5 Mechanical properties 4 7.6 Surface quality .4 7.7 Internal soundness 5 7.8 Dimensions, tolerances on dimensions, and shape .5 8 Inspection, testing, and conformance of products .5 8.1 General .5 8.2 Inspection and testing procedures and types of inspection documents .5 8.3 Specific inspection and testing . 6 8.4 Testmethods. . 6 8.5 Retests .7 Marking 1 9 Annex A (informative) Guidelines for further treatment (including heat treatment) infabrication .29 Annex B (informative) Designations of the steels given in Table 2 and of comparable grades coveredinASTM,EN,JIS,andGBStandards. .34 Annex C (informative) Applicable dimensional standards ..37 Bibliography .38 ii se with I Not for Resale