ISO INTERNATIONAL STANDARD 16063-17 First edition 2016-06-01 Methods for the calibration of vibration and shock transducers - Part 17: Primary calibration by centrifuge Methodes pour I'étalonnage des transducteurs de vibrations et de chocs- Partie 17: Etalonnage primaire par centrifugeur Reference number IS0 16063-17:2016(E) OSI IS0 16063-17:2016(E) Contents Page Foreword .iv 1 Scope 1 2 Normative references .1 3 Terms and definitions ..1 4 Requirements for apparatus and environmental conditions 4.1 Calibration environment. 4.2 Balanced table or arm (rotational table) 4.3 Rotational frequency measuring instrumentation 2 4.4 Voltage-measuring instrumentation 3 5 Preferred values ..3 6 Method 1 (with measurement of the radius of rotation) .3 6.1 Test procedure. .3 6.2 Expression of results .3 7 Method 2 (without measurement of the radius of rotation) 7.1 Test procedure. .4 7.2 Expression of results .4 Annex A (informative) Expression of uncertainty of measurement in calibration 5 Bibliography IS0 16063-17:2016(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. The procedures used to develop this document and those intended for its further maintenance are described in the IsO/IEC Directives, Part 1. In particular the different approval criteria needed for the different types of Iso documents should be noted. This document was drafted in accordance with the editorial rules of the ISo/IEC Directives, Part 2 (see www.iso.org/directives). Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. Iso shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISo list of patent declarations received (see www.iso.org/patents). Any trade name used in this document is information given for the convenience of users and does not constituteanendorsement. For an explanation on the meaning of IsO specific terms and expressions related to conformity assessment, as well as information about IsO's adherence to the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT) see the following URL: www.iso.org/iso/foreword.html. The committee responsible for this document is Iso/TC 108, Mechanical vibration, shock and condition monitoring, Subcommittee Sc 3, Use and calibration ofvibration and shock measuring instruments. This first edition of IS0 16063-17 cancels and replaces IS0 5347-7:1993, which has been technically revised. IS0 16063 consists of the following parts, under the general title Methods for the calibration of vibration and shock transducers: Part 1: Basic concepts -Part 11: Primary vibration calibration by laser interferometry Part 12:Primary vibration calibration by the reciprocity method Part 13: Primary shock calibration using laser interferometry -Part 15: Primary angular vibration calibration by laser interferometry -Part 16: Calibration by Earth's gravitation Part 17:Primary calibration by centrifuge -Part 21: Vibration calibration by comparison to a reference transducer Part 22: Shock calibration by comparison to a reference transducer -Part 31: Testing oftransverse vibration sensitivity Part 32: Resonance testing - Testing the frequency and the phase response of accelerometers by means of shock excitation Part 41: Calibration