ISO INTERNATIONAL STANDARD 14589 First edition 2000-12-15 Blind rivets Mechanical testing Rivets aveugles Essais mécaniques Reference number ISO 14589:2000(E) ISO @ ISO 2000 by IHS under lic Not for Resale ISO14589:2000(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is atrademarkof Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ Iso 2000 - All rights reserved py IHS unde edwithoutlicense from IHS Not for Resale ISO 14589:2000(E) Contents Page Foreword. .iv 1 Scope 2 Normative reference. 3 Shearandtensiletests.... 4 Mandrelheadretentioncapabilitytest.. .8 5 Mandrel push out resistance test (prior to setting).. 6. Mandrelbreakloadtest... 11 Annex A (informative) Example of a suitable test fixture for tensile testing of rivets ..... Copyright Intenafona Organizaion for Standardizalinserved ii d by IHS under license with I: ed without license from IHS Not for Resale